For optimal performance, please use these care procedures to keep the following items regularly cleaned.
Front Caster Wheel
Front caster wheels that are clogged with hair and debris could result in floor damage. Use the following procedure to maintain the front caster wheel.
- Pull firmly on the front wheel to remove it.
- Remove any debris from inside wheel cavity.
- Spin the wheel by hand. If rotation is restricted, remove wheel from its housing and push firmly to remove the axle and clear any debris or hair wrapped around it.
- Reinstall all parts when finished. Make sure the wheel clicks back into place.
Side Brush
- Use a coin or small screwdriver to remove the screw.
- Remove brush, clean the brush and brush post, and reinstall brush.
Cliff Sensors
Wipe the cliff sensors with a clean, dry cloth.
Clean the charging contacts once per week by wiping the charging contacts on the Home Base and robot with a clean, dry cloth.
Charging contacts on the Home Base.
Charging contacts on the robot.
iAdapt® Localisation Camera
Wipe the window on the robot's top surface using a microfiber or soft cotton cloth that has been lightly dampened with water or a screen cleaning solution.
iAdapt® Floor Tracking Sensor
Turn Roomba over and use a clean, dry microfiber or soft cotton cloth to wipe any debris that has accumulated in the round sensor opening on the right side of the robot's bottom surface. Do not spray cleaning solution directly into sensor opening.
